{{indexmenu_n>110}}

# Settings

The **MultiWAN Settings** tab allows you to add or edit multiple [WAN](/glossary/w/wan) connections and turn them on or off. You can also configure thresholds for WAN up/down detection and reliability monitoring.

## Configuration

Below the general settings is a list of selectable WANs.

When a particular WAN is selected, details about it is shown in the configuration section.

^ Item ^ Description ^ Comment ^
| Enabled | Turn WAN on or off. |  |
| Family | Type of WAN. | [IPv4](/glossary/i/ipv4) / [IPv6](/glossary/i/ipv6) |
| Tracking Type | Method to determine if the WAN is online. | `IP` / `Gateway` / ` DNS` |
| Host(s) to ping | List of hosts to [ping](/glossary/p/ping). | Used to determine WAN status.  If this value is not set, the interface is always considered up. |
| Interface Reliability | Number of hosts that must reply for the interface to be considered up. | At least this many hosts must be defined or the interface will always be considered down. |
| Number of Pings | Number of [pings](/glossary/p/ping) to send to each host. |  |
| Timeout | Number of seconds to wait for reply from host. |  |
| Interval | Number of seconds between each test. |  |
| Up | Number of successful tests to consider interface as up. |  |
| Down | Number of failed tests to consider interface as down. |  |


## Overview

{{page>./add}}