Settings
The MultiWAN Settings tab allows you to add or edit multiple WAN connections and turn them on or off. You can also configure thresholds for WAN up/down detection and reliability monitoring.
Configuration
Below the general settings is a list of selectable WANs.
When a particular WAN is selected, details about it is shown in the configuration section.
| Item | Description | Comment |
|---|---|---|
| Enabled | Turn WAN on or off. | |
| Family | Type of WAN. | IPv4 / IPv6 |
| Tracking Type | Method to determine if the WAN is online. | IP / Gateway / DNS |
| Host(s) to ping | List of hosts to ping. | Used to determine WAN status. If this value is not set, the interface is always considered up. |
| Interface Reliability | Number of hosts that must reply for the interface to be considered up. | At least this many hosts must be defined or the interface will always be considered down. |
| Number of Pings | Number of pings to send to each host. | |
| Timeout | Number of seconds to wait for reply from host. | |
| Interval | Number of seconds between each test. | |
| Up | Number of successful tests to consider interface as up. | |
| Down | Number of failed tests to consider interface as down. |